・ Read instruction manual. determined according to EN60745: ・ Only for EU countries Model BKP140 Ni-MH Do not dispose of electric equipment or Li-ion Work mode : planing softwood battery pack together with household Vibration emission (a ) : 3.5 m/s waste material! Uncertainty (K) : 1.5 m/s...
Do not use any Makita Corporation responsible adapter plugs with earthed (grounded) power manufacturer declare that the following Makita tools. Unmodified plugs and matching outlets will machine(s): reduce risk of electric shock. Designation of Machine:...
Page 4
away from moving parts. Loose clothes, terminals together may cause burns or a fire. jewellery or long hair can be caught in moving 27. Under abusive conditions, liquid may be parts. ejected from the battery; avoid contact. If 16. If devices are provided for the connection of contact accidentally occurs, flush with water.
Page 5
SAVE THESE INSTRUCTIONS. 16. Use only Makita blades specified in this manual. Tips for maintaining maximum battery life 17. Always use the correct dust mask/respirator Charge the battery cartridge before completely for the material and application you are discharged.
When the tool is overloaded: • FUNCTIONAL DESCRIPTION At this time, release the switch trigger, remove the battery cartridge and remove causes of overload and then pull the switch CAUTION: trigger again to restart. Always be sure that the tool is switched off and the •...
Page 7
Use only the Makita wrench provided to remove or the adjusting plate. Now slip the heel of the adjusting •...
Page 8
For tool with mini planer blades It is important that the blade sits flush with the inside flank of the gauge plate, the planer blade 1. Socket wrench locating lugs sit in the blade groove and the heel 2. Bolt of the adjusting plate is flush with the back side of 3.
NOTE: coming off during operation. If you connect a Makita vacuum cleaner to this tool, • For tool with nozzle more efficient and cleaner operations can be Attach the dust bag onto the nozzle.
011757 For tool without nozzle When you wish to perform clean planing operation, connect a Makita vacuum cleaner to your tool. Before connecting the vacuum cleaner, remove the chip cover from the tool. Then connect a hose of the vacuum...
Draw a cutting line on the workpiece. Insert the edge fence into the hole in the front of the tool. Align the blade edge with the cutting line. 1. Screw 2. Edge fence (optional accessory) 011748 To make a chamfering cut as shown in the figure, align the "V"...
If you need any assistance for more details regarding the carbon brushes clean and free to slip in the holders. these accessories, ask your local Makita Service Center. Both carbon brushes should be replaced at the same High-speed steel Planer blade time.
Page 16
Makita Corporation Anjo, Aichi, Japan www.makita.com 885009A227...