Maintenance - Makita 3612 Instruction Manual

1
2
3
4
5
003700
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
003701

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1. Wing bolt (A)
2. Guide holder
3. Fine adjusting
screw
4. Wing bolt (B)
5. Wing bolt (C)
6. Trimmer guide
7. Guide roller
7
6
1. Bit
1
2. Guide roller
3. Workpiece
2
1. Limit mark
1
2
1
003702
NOTE:
When replacing carbon brush located on the same
•
side as the knob, remove the knob first before
unscrewing the brush holder cap.
CAUTION:
Be sure to re-install the knob after inserting new
•
carbon brush.
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 minutes.
Then check the tool while running and electric brake
operation when releasing the switch trigger. If electric
brake is not working well, ask your local Makita service
center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Trimmer guide
•
Guide holder
•
Templet guides
•
Templet guide adapter
•
Lock nut
•
Collet sleeve 3/8", 1/4"
•
Wrench 8
•
Wrench 24
•
8
1. Brush holder
cap
2. Knob
3 3. Screwdriver
or attachments
Only use accessory or
are