Table of Contents
Advertisement
Dealing with Problems
Troubleshooting
Starting Up
CF-P2 does not turn on.
Or, there is no display
when CF-P2 is turned on.
The date and time are in-
correct.
CF-P2 shuts down auto-
matically.
The data cannot be copied.
Application Software
The computer locks up
during the execution of an
application, or the execu-
tion speed becomes notice-
ably slower.
62
Check to see if a fully charged battery pack is properly
installed.
The power does not go on unless the Fast Travel Charger
is connected:
The battery level is too low. Charge the battery with the
Fast Travel Charger. (Make sure that the battery never
discharges completely and that it is charged periodically.)
Push the reset switch to restart CF-P2.
If the power does not turn on when the above operations
are performed, the battery pack must be replaced.
You can set the date and time through [Clock &
Alarms] in
- [Settings] - [System] tab.
If you continue to experience problems, the backup
battery maintaining the clock may need to be replaced.
Contact Panasonic Technical Support.
This computer will not correctly recognize the date
and time starting from the year 2085 A.D.
The battery level may be too low. If the battery level
goes below a certain threshold, CF-P2 automatically shuts
down. In such cases, connect the Fast Travel Charger
and charge the battery. (After the Fast Travel Charger is
connected to CF-P2, it may take a maximum of 20 min-
utes before CF-P2 can be turned on.)
The computer may have entered a locked state. If this is
the case, connect the Fast Travel Charger and push the
reset switch. Check the remaining battery level and make
sure that multiple applications are not running simulta-
neously. Close all applications that are not being used.
The computer may be turned off automatically when us-
ing File Explorer. To prevent this, change the time set-
ting to a longer time in
[Power] - [Advanced] tab.
Connect the Fast Travel Charger and push the reset
switch. Check the remaining battery level and make sure
that multiple applications are not running simultaneously.
Close all applications that are not being used.
- [Settings] - [System] tab -
Advertisement
Table of Contents
