Installing the Windows Millennium Driver
1. With the router connected to your PC's USB port, start up your PC in
Windows Millennium, and insert your driver disk.
2. Windows will notify you that new hardware has been detected (shown
above). Select Automatic search for a better drive (Recommended), and
click the Next button.
3. Windows will display a message notifying you that it has finished installing
the driver files on your PC. Click the Finish button.
30
Instant Broadband
Figure 6-17
Figure 6-18
Figure 6-19
Series
™
EtherFast
4. Windows will ask you to restart your PC. Click the Yes button.
5. When your PC is finished restarting, click the Start button, and select
Settings, Control Panel, and Network. Make sure that TCP/IP is installed
for your PC as shown on the screen below. By default, Windows Millennium
has TCP/IP installed. If TCP/IP is not installed, please go to "Appendix D:
Installing the TCP/IP Protocol" for instructions on installation.
Go to "Chapter 7: Configuring Your Network with the Cable/DSL Router."
®
Cable/DSL Routers
Figure 6-20
Figure 6-21
Your USB installation is now complete.
31