Available Running Time For The Supplied Battery Pack; To Remove The Battery Pack; On The Battery Pack - Sony Handycam DCR-SR45 Operating Manual

(Unitmin.)
DCR-SR45ISR46 DCR-SR6S/SRSS
Charging time 125 125
Recording time
Continuous
100 90
recording
110
105
time
Typical
50 45
recording
50 50
time
Playback time
120
120
140 140
On the charging/recording/playback time
• Times measured when using the camcorder at
25°C (77 OF) (lOOC to 30°C (50 OF to 86 OF) is
recommended).
• The available recording and playback time will
be shorter when you use your camcorder in low
temperatures.
• The available recording and playback time will
be shorter depending on the conditions under
which you use your camcorder.
On the battery pack
• Before changing the battery pack or removing
the AC Adaptor from the camcorder, turn
the POWER switch to OFF (CHG) and make
sure that the
1:1
(Movie) lamp/
0
(Still) lamp
(p. 12)/ACCESS lamps (p. 14, 19) is turned off.
• The power will not be supplied from the
battery as long as the AC Adaptor is connected
to the DC IN jack of your camcorder or
the Handycam Station (DCR-SR65/SR85),
even when the power cord (mains lead) is
disconnected from the wall outlet (wall socket).
Top: When the media is set to the hard disk
Bottom: When the media is set to the "Memory
Stick PRO Duo"
U
Notes
• All times measured under the following
settings:
- Recording mode: [SP]
- The LCD backlight turns: [ON]
• Typical recording time shows the time when
you repeat recording start/stop, turning the
power on/off and zooming.
AVfiilablerunning
tirnlefolrth4!i'i
,supp'i,d'batterypack'"
The CHG (charge) lamp turns off when
the battery is fully charged.
Disconnect the AC Adaptor from the
DC IN jack holding both the DC plug
and the Handycam Station (DCR-SR65/
SR85) or your camcorder (DCR-SR45/
SR46).
SAIT (battery)
release lever
o
'0
Charging time:
Approximate time (min.) required to fully
charge a completely exhausted battery
pack.
Recording/Playback time:
Approximate time (min.) available when
you use a fully charged battery pack.
To remove the battery pack
Turn the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
.~.
Tips
• For DCR-SR65/SR85:
Same as DCR-SR45/SR46, you can charge the
battery pack by connecting the AC Adaptor to
your camcorder.
us
10