Arp Access-List - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

arp access-list

To define an ARP access list or add clauses at the end of a predefined list, use the arp access-list
command.
Syntax Description
name
Defaults
This command has no default settings.
Command Modes Global configuration mode
Command History Release
12.1(19)EW
Examples
This example shows how to define an ARP access list named static-hosts:
Switch(config)# arp access-list static-hosts
Switch(config)#
Related Commands Command
deny
ip arp inspection filter vlan
permit
OL-25342 -01
arp access-list name
Specifies the access control list name.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Description
Denies an ARP packet based on matches against the DHCP
bindings.
Permits ARPs from hosts that are configured for static IP when
DAI is enabled and to define an ARP access list and applies it to
a VLAN.
Permits an ARP packet based on matches against the DHCP
bindings.
arp access-list
2-21