Firmware Screen; Figure 113 Firmware Upgrade; Table 71 Firmware Upgrade - ZyXEL Communications Prestige 660H Series User Manual

Prestige 660H/HW Series User's Guide

19.7 Firmware Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
.bin extension, for example, "Prestige.bin". The upload process uses HTTP (Hypertext
Transfer Protocol) and may take up to two minutes. After a successful upload, the system will
reboot. See
firmware using FTP/TFTP commands.
Only use firmware for your device's specific model. Refer to the label on the bottom of your
device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your Prestige.

Figure 113 Firmware Upgrade

The following table describes the labels in this screen.

Table 71 Firmware Upgrade

LABEL
File Path
Browse...
Upload
Reset
Note: Do not turn off the Prestige while firmware upload is in progress!
After you see the Firmware Upload in Process screen, wait two minutes before logging into
the Prestige again.
217
Chapter 35 on page 318
DESCRIPTION
Type in the location of the file you want to upload in this field or click Browse ... to find it.
Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Click Upload to begin the upload process. This process may take up to two minutes.
Click this button to clear all user-entered configuration information and return the
Prestige to its factory defaults. Refer to
in the parts that document the SMT for upgrading
Section 2.1.2 on page 49.
Chapter 19 Maintenance