Cisco Smart Storage NSS322 Quick Start Manual page 7

To remove the disk tray, push the silver tab down to unlock the tray,
and push the lower tab to release the tray lever. Using the tray
lever, pull the tray out.
If your device has the disk drives already installed, continue to
N
OTE
the next section,
Position the disk drive into a disk tray. The electrical connectors of
S 4
TEP
the disk drive must face toward the back of the drive tray.
Attach the disk drive to the tray by inserting the disk drive screws
S 5
TEP
into the four holes at the bottom of the tray and tightening them
with a Phillips screwdriver.
Use the screws provided in the box with the device. Using
N
OTE
other screws can cause damage to your disk or disk tray.
There are clearly marked disk holes to accommodate the following
disk drives:
• 3.5-inch disk drive (use the included silver screws)
• 2.5-inch disk drive (use the included black screws)
Cisco Small Business NSS322 Smart Storage
HDD1
HDD2
LAN
eSATA
NSS 322
Connecting the Equipment, page
Smart Storage
10.
7