Periodic Maintenance - Cobra CR6 Installation And Operation Manual

Re-Fitting the Components to the Range
a. Refit the trivet supports to the Range top,
ensuring that the trivet supports are correctly
fitted.
NOTE:

It is imperative that the trivet supports are
correctly re-fitted to the appliance to ensure that
the burners and trivets locate correctly and sit
flush and level.

Note the orientation of the trivet supports when
re-fitting. The trivet support front side rail profiles
are different from the rear side rail profiles and
will only fit one way to the cooktop.
b. Refit the burners and burner caps onto the
Range cooktop.
c. Refit the trivets to the cook top, taking note that
the trivets are manufactured with a lip on one
edge, the lip must always be fitted to the outer
edge (front and back) of the range.
d. Refit the spill / grease tray(s) to the range.
Oven Interior
a. Do not use wire brushes, steel wool or other
abrasive materials to clean the oven interior.
b. Clean the oven regularly with a good quality
domestic oven cleaner.
c. Once a week, remove and clean any built up of
grease etc. from the oven racks and the bottom
spill over cover.
d. Dry the oven thoroughly with a dry cloth and
polish with a soft dry cloth.

Periodic Maintenance

NOTE:
All maintenance operations should only be carried
out by a qualified service person.
To achieve the best results cleaning must be regular
and thorough and all controls and mechanical
parts should be checked and adjusted periodically
by a qualified service person. If any small faults
occur, have them attended to promptly. Don't wait
until they cause a complete breakdown. It is
recommended that the appliance is serviced every
6 months.
Part 5 Cleaning and Maintenance
Gas Control Valve Re-Greasing
The gas control valve should be dismantled and
greased every 6 months to ensure the correct
operation of the gas control valve.
To carry out this operation;-
a. Remove the gas control knobs from the gas tap
spindles by pulling the knobs away from the
control panel.
b. Remove the drip tray from the appliance.
c. Remove the two screws on the underside of the
control panel, securing the control panel to the
hob.
d. Remove the control panel from the front of the
appliance.
e. Remove the 2 screws holding the shaft plate to
the gas control body and remove the control
shaft and plate. Note the orientation of shaft for
correct re-assembly.
f. Using needle nose pliers or similar, pull out the
gas control spindle, again noting its orientation.
g. Apply a suitable high temperature gas cock
grease or lubricant such as ROCOL - A.S.P (Anti
scuffing paste) / Dry Moly Paste to the outside of
the spindle.
h. Replace spindle and re-assemble the gas
control valve in reverse order.
i. Refit the control panel to the appliance and
secure with the 2 screws.
j. Refit the knobs to the gas control valve spindles.
14
Two Screws
Spindle