Ip->Tel Routing - D-Link DVG‐6008G User Manual

Route calls after The parameters indicate that the gateway will select Tel->IP routes after
manipulation number manipulation completed
Route calls before The parameters indicate that the gateway will select Tel->IP routes
manipulation before number manipulation completed
4.7.2 IP->Tel Routing
Parameters
This item uses to configure outgoing call routes which can be used for
IP ->Tel Routing
receive the calls from the IP side
It uniquely identifies a route. Its value is assigned globally, ranging from
0 to 31.The route preferentially match the rules which the value of index
Index
is smaller. Index 31 is default route on gateway which to be match all
prefixes.
It describes the route for the ease of identification. Its value is character
Description
string
Source IP It specifies the IP of the caller
All the caller number must match the source prefix. It specifies the
source prefix allow to send call out
Source Prefix  Any: include anonymous, 0xxxx, 1[2-9]xxxx etc.
 0xxxx: consist of some digits such as 015,08,09
 1[3-8]6:consist of some prefix, include 136,146,156,166,176, 186
All the called number must match the destination prefix, the call prefix
indicates the connected number
Destination Prefix  Any: include anonymous, 0xxxx, 1[2-9]xxxx etc.
 0xxxx: consist of some digits such as 015,08,09
1[3-8]6:consist of some prefix, include 136,146,156,166,176, 186
_______________________________________________________________________________
D-Link Corporation
Figure 4-7-2 IP to Tel Routing
Table 4-7-2 Description of IP to Tel Routing
DVG-6008G VoIP Gateway User Manual
Description
36