Removing The Compressor (Mc); Removing The Power Receiver - Mitsubishi Electric PUHZ-SW40VHA Service Manual

OPERATING PROCEDURE

12. Removing the compressor (MC)

(1) Remove the service panel. (See Photo 2)
(2) Remove the top panel. (See Photo 1)
(3) Remove the front panel. (See Photo 1)
(4) Remove the back panel. (See Photo 1)
(5) Remove the electrical parts box. (See Photo 5)
(6) Remove the thermistor <Discharge> (TH4) and thermistor
<Comp. surface> (TH34). (See Photo 13)
(7) Remove 3 separator fixing screws (4 × 10) and remove the
separator.
(8) Recover refrigerant.
(9) Remove 3 compressor fixing nuts by using a spanner or an
adjustable wrench.
(10) Remove the welded pipe of motor for compressor inlet
and outlet.
Note: Recover refrigerant without spreading it in the air.

13. Removing the power receiver

(1) Remove the service panel. (See Photo 2)
(2) Remove the top panel. (See Photo 1)
(3) Remove the front panel. (See Photo 1)
(4) Remove the back panel. (See Photo 1)
(5) Remove the electrical parts box. (See Photo 5)
(6) Recover refrigerant.
(7) Remove 4 welded pipes of power receiver inlet and outlet.
(8) Remove 2 receiver leg fixing screws (4 × 10).
(9) Remove the power receiver together with the receiver leg.
Note: Recover refrigerant without spreading it in the air.
OCH525
Photo 13
Thermistor<Discharge>
(TH4)
Separator
Compressor
(MC)
Separator
fixing screw
Photo 14
Outlet
Power receiver
59
PHOTOS
Thermistor
<Comp.surface> (TH34)
Compressor Valve bed
fixing nut
Receiver leg Receiver leg
fixing screw
Power receiver
Inlet