OPERATING PROCEDURE
12. Removing the compressor (MC)
(1) Remove the service panel. (See photo 2.)
(2) Remove the top panel. (See photo 1.)
(3) Remove the front panel. (See photo 1.)
(4) Remove the back panel. (See photo 1.)
(5) Remove the electrical parts box. (See photo 5.)
(6) Remove 3 separator fixing screws (4
the separator.
(7) Recover refrigerant.
(8) Remove 3 compressor fixing nuts by using a spanner or a
adjustable wrench.
(9) Remove the welded pipe of motor for compressor inlet
and outlet.
Note: Recover refrigerant without spreading it in the air.
13. Removing the power receiver
(1) Remove the service panel. (See photo 2.)
(2) Remove the top panel. (See photo 1.)
(3) Remove the front panel. (See photo 1.)
(4) Remove the back panel. (See photo 1.)
(5) Remove the electrical parts box. (See photo 5.)
(6) Recover refrigerant.
(7) Remove 4 welded pipes of power receiver inlet and outlet.
(8) Remove 2 receiver leg fixing screws (4
(9) Remove the power receiver together with the receiver leg.
Note: Recover refrigerant without spreading it in the air.
Photo 13
10) and remove
Compressor
(MC)
Separator
Separator
fixing screw
Photo 14
10).
Outlet
133
PHOTOS
Valve bed
Compressor
fixing nut
Inlet
Power
receiver
Receiver leg
Receiver leg
fixing screw
Power
receiver