Andset Sound Signals; Roubleshooting Uide; T Roubleshooting G Uide - GE 27958 User Manual

H S
ANDSET OUND
Signal
A long warbling tone (with ringer on)
Three short beeps
One short beep (every 7 seconds)
T
ROUBLESHOOTING
T S
ELEPHONE OLUTIONS
No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet .
Ensure the telephone line cord is connected to the base and the wall jack .
• Connect another phone to the same jack; if there is still no dial tone, the problem might
be your wiring or local service.
• The cordless handset may be out of range of the base. Move closer to the base.
• Ensure the battery is properly charged (12 hours).
• Ensure the battery pack installed correctly.
• Did the handset beep when you pressed the TALK/CALLBACK button? The battery may
need to be charged.
• Place handset in charge cradle for at least 20 seconds.
Dial tone is OK, but can't dial out
• Make sure the TONE/PULSE setting on the base is set to the type of phone service you are
subscribed to.
Handset/Base does not ring
• Make sure the handset ringer switch is turned on and the base ringer is programmed to HI.
• The cordless handset may be out of range. Move closer to the base.
• You may have too many extension phones on your line. Try unplugging some phones.
• Check for dial tone. If no dial tone is heard, see No dial tone above.
You experience static, noise, or fading in and out
• Change channels.
• The cordless handset may be out of range of the base. Move closer to the base.
• Move closer to base (cordless handset might be out of range).
• Make sure base is not plugged into an outlet with another household appliance.
• Charge the battery.
40
S
IGNALS
G
UIDE
Meaning
Signals an incoming call
Page signal
Low battery warning