Handset Sound Signals; Troubleshooting Guide; Telephone Solutions - GE 25835 User Manual

Handset Sound Signals

Signal
A long warbling tone (with ringer on)
Three short beeps
One short beep (every 7 seconds)

Troubleshooting Guide

Telephone Solutions

No dial tone
• Check or repeat installation steps:
Make sure the base power cord is connected to a working
electrical outlet.
Make sure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack. If it doesn't work, the problem
might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Make sure the battery is properly charged (for 16 hours).
• Make sure the battery pack (in the handset) is properly installed.
• The handset should beep when you press theTALK/CALLBACK button, and
the charge indicator on the base should be lit when the handset rests in the
cradle. If not, the battery may need to be charged.
• Place handset in charge cradle for at least 20 seconds to reset the unit.
Handset does not ring
• Make sure the handset ringer software switch is set to on.
• The handset may be out of range of the base. Move closer to the base.
• You may have too many extension phones on your line.Try unplugging
some extension phones.
Meaning
Signals an incoming call
Page signal
Low battery warning
37