Presentation Mode; Presentation Led Behavior After Decode - Honeywell Xenon 1900 User Manual

device is programmed for
tation mode whenever it is in the stand, and in manual trigger mode whenever it
is removed from the stand. Default = Sensor On.
* Sensor On

Presentation Mode

Presentation Mode uses ambient light to detect bar codes. The LEDs remain
off until a bar code is presented to the scanner, then the LEDs turn on automat-
ically to read the code. If the light level in the room is not high enough, Presen-
tation Mode may not work properly.
Note: If you are using a cordless device in Presentation Mode, the battery will
not charge unless the power supply is plugged into the base's auxiliary
power port.

Presentation LED Behavior after Decode

When a scanner is in presentation mode, the LEDs remain on and continue
scanning for a short time after a bar code is decoded. If you wish to turn
the LEDs off immediately after a bar code is decoded, scan the LEDs Off
bar code, below. Default = LEDs On.
* LEDs On
Presentation Mode
Presentation Mode
(page 4-9), it would be in presen-
Sensor Off
LEDs Off
4 - 9