Table of Contents
Advertisement
PDN Gateway Configuration
Step 1
Set system configuration parameters such as activating PSCs by applying the example configurations found in the
System Administration Guide.
Step 2
Set initial configuration parameters such as creating contexts and services by applying the example configurations
found in the
Initial Configuration
Step 3
Configure the system to perform as a P-MIP P-GW and set basic P-GW parameters such as P-MIP interfaces and an IP
route by applying the example configurations presented in the
Step 4
Configure the PDN context by applying the example configuration in the
Step 5
Enable and configure the active charging service for Gx interface support by applying the example configuration in the
Active Charging Service Configuration
Step 6
Create a AAA context and configure parameters for AAA and policy by applying the example configuration in the
AAA and Policy Configuration
Step 7
Verify and save the configuration by following the instruction in the
Initial Configuration
Step 1
Set local system management parameters by applying the example configuration in the
section.
Step 2
Create the context where the P-GW service will reside by applying the example configuration in the
Configuring a P-MIP P-GW Context
Configuring the System as a Standalone PMIP P-GW Supporting an eHRPD Network ▀
section of this chapter.
section.
section.
section.
Cisco ASR 5x00 Packet Data Network Gateway Administration Guide ▄
P-GW Service Configuration
P-GW PDN Context Configuration
Verifying and Saving the Configuration
Modifying the Local Context
section.
section.
section.
Creating and
165
Advertisement
Table of Contents
