Assume Positive For Gx - Cisco ASR 5x00 Administration Manual

▀ Assume Positive for Gx

Assume Positive for Gx
In a scenario where both the primary and secondary PCRF servers are overloaded, the PCRF returns an error to P-GW
and HSGW. Current behavior for the P-GW and HSGW is to terminate the session if both primary and secondary return
a failure or timeout.
This feature is developed to enhance this behavior by applying local policy on the GW to ensure that the subscriber
session continues. P-GW / HSGW should implement Assume Positive feature to handle errors and based on the event
type implement specific rules.
Important:
representative for information on how to obtain a license.
The failure handling behavior is enhanced to ensure that the subscriber service is maintained in case of PCRF
unavailability. It is also required that the GW reduces the traffic towards the PCRF when receiving a Diameter Too
Busy (3004) by stopping the transmission and reception of Diameter messages (CCRs and RARs) to and from the PCRF
for a configurable amount of time.
In case of any of the following failures with PCRF, the GW chooses to apply failure handling which results in
subscriber termination or to allow browsing without any more policy enforcement.
 TCP link failure
 Application Timer (Tx) expiry
 Result code based failures
In 14.1 and later releases, the PCRF is allowed to fall back to Local Policy for all connection level failures, result
code/experimental result code failures. Local Policy may choose to allow the subscriber for a configured amount of
time. During this time any subscriber/internal event on the call would be handled from Local Policy. After the expiry of
the timer, the subscriber session can be either terminated or else PCRF can be retried. Note that the retry attempt to
PCRF happens only when the
The fallback support is added to the failure handling template and the local policy service needs to be associated to IMS
Authorization service.
Once the local policy is applied, all PCRF enabled event triggers shall be disabled. When the subscriber session is with
the local-policy, the GW skips sending of CCR-T and cleans up the session locally.
For a session that was created with active Gx session, the GW sends the CCR-T to primary and on failure sends the
CCR-T to the secondary PCRF. If the CCR-T returns a failure from both primary and secondary or times out, the GW
cleans up the session locally.
Fallback to Local Policy is done in the following scenarios:
 Tx timer expiry
 Diabase Error
 Result Code Error (Permanent/Transient)
 Experimental Result Code
 Response Timeout
The following points are applicable only in the scenario where reconnect to PCRF is attempted.
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
328
Use of Gx Assume Positive requires that a valid license key be installed. Contact your Cisco account
timer-expiry event
is configured as
reconnect-to-server
Gx Interface Support
.