Cisco SPA1112 Provisioning Manual page 84

Voice Parameters
<Forced_Resync_Delay>
<Resync_From_SIP>
<Resync_After_Upgrade_Attempt>
<Resync_Trigger_1>
<Resync_Trigger_2>
<Resync_Fails_On_FNF>
<Profile_Rule>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
Maximum delay (in seconds) that the ATA waits before
performing a resync.
The ATA does not resync while one of its lines is active.
Because a resync can take several seconds, it is desirable to
wait until the ATA has been idle for an extended period before
resynchronizing. This allows a user to make calls in
succession without interruption.
The ATA has a timer that begins counting down when all of its
lines become idle. This parameter is the initial value of the
counter. Resync events are delayed until this counter
decrements to zero.
Default setting: 14400 seconds
Enables a resync to be triggered via a SIP NOTIFY message.
Default setting: yes
Triggers a resync after every firmware upgrade attempt.
Default setting: yes
Configurable resync trigger conditions. A resync is triggered
when the logic equation in these parameters evaluates to
TRUE.
Default setting: blank
Determines whether a file-not-found response from the
provisioning server constitutes a successful or a failed resync.
A failed resync activates the error resync timer.
Default setting: yes
This parameter is a profile script that evaluates to the
provisioning resync command. The command is a TCP/IP
operation and an associated URL. The TCP/IP operation can
be TFTP, HTTP, or HTTPS.
If the command is not specified, TFTP is assumed, and the
address of the TFTP server is obtained through DHCP option
66. In the URL, either the IP address or the FQDN of the server
can be specified. The file name can have macros, such as
$MA, which expands to the ATA MAC address.
Default setting: /spa$PSN.cfg
6
84