Chapter 4
Security > Port Security
The Port Security screen is used to configure a port's
security settings.
Security > Ports Security
Network security can be increased by limiting access on
a specific port only to users with specific MAC addresses.
MAC addresses can be dynamically learned or statically
configured.
Locked port security monitors both received and learned
packets that are received on specific ports. Access to the
locked port is limited to users with specific MAC addresses.
These addresses are either manually defined on the port,
or learned on that port up to the point when it is locked.
When a packet is received on a locked port, and the
packet's source MAC address is not tied to that port (either
it was learned on a different port, or it is unknown to the
system), the protection mechanism is invoked, and can
provide various options. Unauthorized packets arriving at
a locked port are either:
Forwarded
•
Discarded
•
Cause the port to be shut down
•
Locked port security also enables storing a list of MAC
addresses in the configuration file. The MAC address list
can be restored after the device has been reset.
Disabled ports can be reactivated from the Port Settings
screen of the Port Management tab.
Interface
Select Port or LAG, then select the desired
interface from the appropriate drop-down menu.
Lock Interface
Select this option to lock the interface.
The default is not selected (interface not locked).
Busness Seres Smart Ggabt Ethernet Swtch
Configuration Using the Web-based Utility
Learnng Mode
Defines the locked port type. This field
is enabled only if Lock Interface is not selected. The
possible values are:
Classc Lock
Locks the port using the classic lock
•
mechanism. The port is immediately locked, regardless
of how many addresses have already been learned.
Lmted Dynamc Lock
•
the current dynamic MAC addresses associated with
the port. The port learns up to the maximum number
of addresses allowed on the port. Both relearning and
aging MAC addresses are enabled.
In order to change the Learning Mode, the Lock Interface
must be unselected. Once the Learning Mode is changed,
the Lock Interface can be reinstated.
Max Entres
Specifies the number of MAC addresses
that can be learned on the port. This field is enabled only
if Learning Mode is set to Lmted Dynamc Lock. The
default value is .
Acton on Volaton
Indicates the action to be applied to
packets arriving on a locked port. The possible values are:
Dscard
Discards packets from any unlearned source.
•
This is the default value.
Forward
Forwards packets from an unknown source
•
without learning the MAC address.
Shutdown
Discards packets from any unlearned
•
source and shuts down the port. The port remains shut
down until reactivated, or until the device is reset.
Update
If you click this button, your changes are saved
and appear immediately in the table at the bottom of the
Port Security screen.
The lower portion of the Port Security screen displays
a summary of the settings in the upper portion of the
screen. The settings are displayed for each of the ports
on the Switch.
Click Save Settngs to apply the changes, or Cancel
Changes to cancel the changes.
Locks the port by deleting