Table of Contents
Advertisement
Chapter 4
Port Management > LACP
In addition to LAGs that you create by manually grouping
ports together, you can also use the Link Aggregation
Control Protocol (LACP) to automatically negotiate a LAG
link between the Switch and another network device.
The LACP screen contains fields for configuring LACP LAGs.
This screen is divided into three parts: Global Parameter,
Port Priority, and LACP Port Table.
Port Management > LACP
Global Parameter
LACP System Prorty
The global LACP priority value,
from to 6. The default value is .
Port Priority
Port
The port number to which the timeout and priority
values are assigned. To configure a different port, select it
from the drop-down menu. If you do not see the port you
want, click Next in the LACP Port Table.
LACP Port Prorty
Defines the LACP priority value for
the port, from to 6. The default value is .
LACP Tmeout
The administrative LACP timeout value.
Select either Short or Long (default).
Admn Key
(Read-only) A channel will only be formed
between ports with the same admin key. This only applies
to ports located on the same switch.
When you are finished entering the settings above, click
Update to apply the settings.
LACP Port Table
This section provides a read-only display of the current
LACP settings.
After you are finished setting the LACP parameters,
click Save Settngs to save the settings, or click Cancel
Changes to cancel your changes.
Busness Seres Smart Ggabt Ethernet Swtch
Configuration Using the Web-based Utility
Port Management > PoE Power Settings
NOTE:
This section applies ONLY to the
SLM4P and SLM48P Smart Switches.
The PoE Power Settings screen allows you to configure the
Power over Ethernet (PoE) ports on the Switch.
Port Management > PoE Power Settngs
Port
Displays the port number.
Admn Status
Check the checkbox to enable PoE power
to be supplied to the connected device.
Prorty
Select Crtcal, Hgh, or Low (default) from the
drop-down menu to set the priority of the port.
Power Allocaton (mllwatts)
in milliwatts that can be supplied to the port.
Power Consumpton (mllwatts)
currently being used by the connected PoE device.
Click Save Settngs to save the changes, or click Cancel
Changes to cancel your changes.
Sets the maximum power
Displays the power
7
Hide quick links:
Advertisement
Table of Contents
