Advertisement
Installing or removing battery cartridge
0
Always switch off the tool before insertion or removal of the battery cartridge.
0
To remove the battery cartridge, pull out
the s e t plate and grasp both sides of the
cartridge while withdrawing it from the
tool.
0
To install the battery cartridge, insert the
battery cartridge into the housing and
snap the set plate back into place. Be sure
t o close the set plate fully before using
the tool.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port so
that it rests on the charger port floor.
Press the start button (red). The charging
liqht will come on and charging will begin.
Battery cartridge
1
Reset button
-
-
l f t h e charging light does not come on, press the reset button (yellow) first, then the start
button (red). If the charging light goes out within
10
seconds even after pressing the reset
button and start button a couple of times, the battery cartridge i s dead. (CAUTION : Wait
for more than 5 seconds after the charging light goes out t o press the reset button again.)
Replace it with a new one. When the charging light goes out after about one hour, you
may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION :
*Your new battery cartridge i s not charged. You will need to charge it before use.
0
Do not keep the button pressed in with tape, etc., or the circuit will not function pro-
perly. Also, a malfunction of the charger may result possibly causing overheating, etc.
0
If you try to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it
and try t o charge i t once more.
0
When you charge a new battery cartridge or
a
battery cartridge which has not been used
for a long period, it may not accept a full charge. This is a normal condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging it
almost completely a couple of times.
0
If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
6
Advertisement
