Array Diagnostic Utility; Hp Systems Insight Manager; Usb Support And Functionality; Usb Support - HP ProLiant DL320 Generation 5p Maintenance And Service Manual

Hp proliant dl320 generation 5p server
Hide thumbs Also See for ProLiant DL320 Generation 5p:
Table of Contents

Advertisement

Array Diagnostic Utility

The HP Array Diagnostics Utility is a web-based application that creates a report of all HP storage
controllers and disk drives. This report provides vital information to assist in identifying faults or conditions
that may require attention. ADU can be accessed from the SmartStart CD or downloaded from the HP
website (http://www.hp.com).

HP Systems Insight Manager

HP SIM is a web-based application that allows system administrators to accomplish normal administrative
tasks from any remote location, using a web browser. HP SIM provides device management capabilities
that consolidate and integrate management data from HP and third-party devices.
IMPORTANT:
processors, SAS and SATA hard drives, and memory modules.
For additional information, refer to the Management CD in the HP ProLiant Essentials Foundation Pack or
the HP SIM website (http://www.hp.com/go/hpsim).

USB support and functionality

USB support (on page 60)
Internal USB functionality (on page 60)

USB support

HP provides both standard USB support and legacy USB support. Standard support is provided by the
operating system through the appropriate USB device drivers. HP provides support for USB devices before
the operating system loads through legacy USB support, which is enabled by default in the system ROM.
HP hardware supports USB version 1.1 or 2.0, depending on the version of the hardware.
Legacy USB support provides USB functionality in environments where USB support is normally not
available. Specifically, HP provides legacy USB functionality for:
POST
RBSU
Diagnostics
DOS
Operating environments which do not provide native USB support
For more information on ProLiant USB support, refer to the HP website
(http://h18004.www1.hp.com/products/servers/platforms/usb-support.html).

Internal USB functionality

An internal USB connector is available for use with USB drive keys only. The internal connector shares the
same bus with the front external USB connector, and connecting a device to both the front internal and
front external USB connectors is not supported. This solution provides for use of a permanent boot drive
You must install and use HP SIM to benefit from the Pre-Failure Warranty for
Diagnostic tools 60

Advertisement

Table of Contents
loading

Table of Contents