Honda HP400 Owner's Manual page 53

6. Remove the sprocket.
7. Place the track over the driven wheel, and engage the sprocket with the
track teeth.
8. Push the sprocket and track toward the rear, then slide the sprocket onto
the sprocket shaft.
9. Install and tighten the sprocket bolts securely.
DRIVEN WHEEL
SPROCKET BOLT
TRACK
\
DRIVEN WHEEL
SPROCKET
10. Remove the wooden blocks and make sure the power carrier is level.
Then adjust track tension.
1 NOTICE 1
l
Special care should be exercised when mounting the tracks.
l
Do not tip the carrier onto its side; oil and gasoline may spill out. Tip
it only enough to ease track installation.
l
After following the above temporary procedure, have the power
carrier inspected by your authorized Honda dealer as soon as pos-
sible.
51