Cisco 6000 Series Site Planning Manual page 19

Chapter 2 Power and Cooling
Figure 2-1
1 NEBS bonding and grounding point (upper)
2 NEBS bonding and grounding point (lower)
To connect the chassis to a NEBS-compliant bonding and grounding system at your site, you must have
the following:
One 180-degree angle (straight) grounding lug that has two M6 bolt holes with 0.63 inch spacing
•
center to center between them, and a wire receptacle able to accept a 6-AWG copper wire
(Figure
Four M6 bolts with integrated square cone locking washers (shipped pre-installed on the chassis,
•
two at each grounding point).
Note
Cisco recommends 2-6-AWG multistrand copper ground cable. This cable is not available from
•
Cisco; it is available from any commercial cable vendor. The cable should be sized according to
local and national installation requirements.
The DC Return of the Cisco NCS 6008 chassis should remain isolated from the system frame and chassis
Caution
(DC-I: Isolated DC Return).
OL-29236-02
NEBS Bonding and Grounding Points—Rear Side of Chassis
2-2).
The chassis ground wire connectors have a torque value of 30 in-lb (3.39 N-m).
Cisco Network Convergence System 6000 Series Routers Site Planning Guide
Bonding and Grounding Guidelines
1
2
2-3