Linksys Instant Wireless Series User Manual page 8

2. The screen shown in Figure 5-2 shows the two ways to configure the Bridge
using this Setup Wizard. Optimally, you should perform this setup through
a PC on your wired network. You can also set up the Bridge through one of
the PCs on your wireless network. Click the Next button to continue or the
Exit button to exit the Setup Wizard.
3. The screen shown in Figure 5-3 displays a list of Wireless Ethernet Bridges
on your network, along with the status information for each Bridge. (If you
have only one Bridge on your network, it will be the only one displayed.)
Select the Bridge you are currently installing by clicking its name in the
Selection box. Write down the IP address of the Wireless Ethernet Bridge,
so you can use it to access the Web-Based Utility later. Click the Yes but-
ton to continue or the Exit button to exit the Setup Wizard.
10
Instant Wireless
Figure 5-2
Figure 5-3
Series Wireless Ethernet Bridge
TM
4. For security purposes, you will be asked for your user name and password
in order to access the Bridge. In lowercase letters, enter admin in the
Password field (later you can change the password through the Web-Based
Utility). Click the Yes button to continue or the No button to return to the
previous screen.
5. The screen shown in Figure 5-5 shows a choice of two wireless modes.
Click the Infrastructure Mode radio button if you want your wireless
computers to network with computers on your wired network using a wire-
less access point. Click the Ad-Hoc Mode radio button if you want multi-
ple wireless computers to network directly with each other. Do not use the
Ad-Hoc mode if you want to network your wireless computers with com-
puters on your wired network. Click the Next button to continue or the
Back button to return to the previous screen.
Figure 5-4
Figure 5-5
11