Honda 2005 Civic Owner's Manual page 95

Main Menu Table of Contents
To Play the Radio
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
Power Volume knob or the AM/FM
button (FM/AM button on models
with in-dash CD changer). Adjust the
volume by turning the Power
Volume knob.
On models with in-dash CD changer
As you adjust a volume, you will hear
a beep whenever the adjustment
level reaches the maximum and
minimum of its range.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
or FM/AM button. On the FM band,
ST will be displayed if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
On models with in-dash CD changer
On the AM band, AM noise
reduction turns on automatically.
To Select a Station
You can use any of five methods to
find a radio station on the selected
band: TUNE, SEEK, SCAN,
preset buttons, and AUTO SELECT
TUNE Use the TUNE knob or
the SEEK bar to tune the radio to a
desired frequency.
Except for models with in-dash CD
changer
Turn the knob to the right to tune a
higher frequency, and turn it to the
left to tune a lower frequency.
On models with in-dash CD changer
Press the side of the SEEK bar
to tune a higher frequency, and
press the side to tune a lower
frequency.
Playing the Radio
SEEK The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
SEEK bar, then release it.
On models with in-dash CD changer,
the press the
. SEEK bar until you hear a beep, then
release it.
Except for models with in-dash CD
changer
SCAN The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan for
a station with a strong signal. When
it finds one, it will stop and play that
station for about 5 seconds.
or side of the
or side of the
CONTINUED
93