Cisco CATALYST 6500 WS-X6066-SLB-S-K9 Installation Note page 16

Installing the CSM-S
Figure 3
Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create
c.
a small (0.040 inch [1 mm]) gap between the EMI gasket and the module above it. (See
Pressing down too firmly on the levers will bend and damage them.
Caution
While pressing down, simultaneously close the left and right ejector levers to fully seat the module
d.
in the backplane connector. The ejector levers are fully closed when they are flush with the module
faceplate. (See
Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note
16
Clearing the EMI Gasket in a Horizontal Slot Chassis
WS-X6K-SU P2-2GE
1
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
WS-X6K-SU P2-2GE
2
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
3
Press down
4
WS-X622 4
5
24 PORT 100FX
6
3
4
4
WS -C6 500 -SF
M
5
5
SW ITC H FAB IRD
MD L
6
6
Figure 4.)
Switch Load
100%
PORT 1
PCMCIA
EJECT
1%
Switch Load
100%
PORT 1
PCMCIA
EJECT
1%
1 mm Gap between the module
EMI gasket and the
module above it
PORT 2
PORT 2
Press down
Figure
78-16856-01
3.)