Honeywell HCD92534 Quick Install Manual

HCD92534 Camera
Quick Install Guide
Installation
The HCD92534 camera is designed for installation on a wall or
ceiling. The HCD92534 is weather sealed for indoor or outdoor
locations.

Attaching the Camera

1. Position the camera to the desired mounting location on a
solid, flat surface (for example, a crossbeam).
2. Using the supplied mounting template, mark the four screw
holes for installation and screw in the camera.
The mounting bracket can be separated from the camera
housing for easier installation. This is done by unscrewing and
removing the thumb screw on the bracket (see below).
Mounting Bracket
thumb screw
water drain notch
Note To ensure a waterproof installation, the notch in the
camera base that the power and video connections exit
through should be facing down.
Positioning the Camera
Caution Do not swivel and position the camera without the
mounting bracket firmly in place.
Loosen the thumb screws and move the camera into position.
Swivel the camera to capture the desired field of view. Tighten the
thumb screws to set the position.
Lens Setup
Adjusting the Zoom and Focus of the Lens
The zoom and focus adjustment is accessible at the underside
front end of the camera housing.
Document No. 800-00273 – Rev A – 04/07
Lens Controller
F
Z
Use a flathead screwdriver to adjust the zoom and/or focus.
To adjust the focus turn the focus screw counter-clockwise for
near focus and clockwise for far.

Camera Settings

Camera Functions

Camera Controller
VIDEO-TEST
1
LUX LEVEL
UP
4 LEFT RIGHT
DOWN
SETUP (MENU)
PUSH DOWN
3
LED-LEVEL
Legend
# Description
1 Video-test monitor output connector
2 LUX-level adjustment DIP switches. Only one switch should be on at
a time. They modify the point at which the lux threshold (level of
light) changes the mode of operation (color or B/W).
STEP Color to B/W (LED on) B/W to Color (LED off)
1 11–12 lux
2 8–9 lux
3 6–7 lux
4 1–3 lux
3 LED-level adjustment screw. Increase (turn clockwise) or lower (turn
counter-clockwise) the IR LED brightness in night (B/W) mode.
4 Camera OSD control (four position plus center push)
Press this control To do this
UP, DOWN
LEFT, RIGHT
SETUP (MENU)
Focus adjustment screw
Zoom adjustment
screw
ON
1 STEP
2 STEP
3 STEP
4 STEP
2
12–13 lux
10–11 lux
7–8 lux
3–5 lux
Select a new item
Select a menu item
Access a submenu