Cisco 4430 Introducing page 7

Chapter 1 Introducing the Content Router 4430
Figure 1-3 Identifying a Rollover Cable
Pin 1
Network Cables
Note
78-12541-01
Pin 1 and pin 8
should be the
same color
An Ethernet cable is required to connect the Content Router 4430 to your network.
To connect the Content Router 4430 to your network, you must use one of the
following types of cables:
Unshielded twisted-pair (UTP) straight-through cable with RJ-45 connectors
•
to connect the Content Router 4430 to a Medium Dependent
Interface-crossover (MDI-X) port
• RJ-45 to RJ-45 crossover cable to connect the Content Router 4430 to another
MDI port
The Ethernet ports on the Content Router 4430 are MDI.
Use a Category 5 UTP cable to connect to a 100BASE-T network.
Pin 8
Cisco Content Router 4430 Hardware Installation Guide
System Hardware Features
1-7