Connecting The Network Cable - D-Link DGE-550SX User Manual

3. Install the bracket screw that secures the card to the
computer chassis.
4. Replace the computer's chassis cover.
5. Reconnect the computer's power cord, and switch
computer power on. If the BIOS section of your
computer's boot program is Plug-and-Play compliant,
then at power-up the BIOS will automatically configure
any newly installed DGE-550SX adapter.
NOTE: Due to a fault in some Plug-n-Play BIOS programs, it
happens occasionally that a newly installed adapter is
assigned an Interrupt Number which is already
assigned to another device. In such a case, a conflict in
the Interrupt Number will cause faults in the behavior
of both devices. Then it is necessary to run the CMOS
Setup utility, and manually assign a non-conflicting
Interrupt Number to the PCI bus slot that the DGE-
550SX is install in.

Connecting the Network Cable

The DGE-550SX 1000Base-SX Gigabit Ethernet network
adapter card enables operation over 850nm 62.5/125 fiber
optic cable to 220 meters and 850nm 50/125 fiber optic cable
to 500 meters. The network adapter card uses two SC sockets
to terminate the fiber optic cable. The upper socket is used to
transmit packets and the lower socket is used to receive
packets.
Installation
DGE-550SX 1000 Mbps PCI Adapter
5