Thermometer Adjustment - Honeywell T8095A/191108AJ Owner's Manual

Thermometer Adjustment

The thermometer was accurately calibrated at
the factory and should only need adjustment if it
was dropped or mishandled.
If the setpoint lever and the thermometer
reading do not agree, use the following procedure:
1. Remove thermostat cover and open the
flip-up cover.
2. Set the thermostat cover on a table near a
thermometer of known accuracy.
3. Allow at least five minutes for cover
thermometer to sense area temperature, then
compare the readings. Be careful not to touch
thermometer or breathe on it.
4. If the readings are the same, replace the
cover and put the system into operation.
5. If the readings are different, insert a small
screwdriver in the thermometer slot, see Fig. 7,
and turn it until both thermometers read the
same.
6. Replace the thermostat cover and put the
system into operation.
THERMOMETER
SLOT
Fig. 7—Thermometer Adjustment.
24
BACKSIDE OF
FLIP-UP COVER
INSERT AND TURN
SCREWDRIVER
M1810