Advertisement
T7022A REMOTE TEMPERATURE SENSOR
Duct Mounting
DRILL 5/16 INCH
HOLE FOR SENSOR
(DRILL 3/8 INCH
HOLE IF EXTENSION
TUBE IS USED).
SETSCREW
BRACKET
Fig. 2. Duct mounting with mounting bracket.
Light Troffer Mounting
NOTE: Fig. 4 and 5 illustrate T7022 mounting for individual zone control. This type of application requires the use of
an M7034 Electronic Modutrol
setpoint adjustment, if desired.
Fig. 4. Cross section of light troffer showing a typical
mounting location of the side of the light troffer.
CHECKOUT
Move set point above and below room temperature to
make sure controlled equipment operates properly. See
other system component instructions for additional
checkout procedures.
Home and Building Control Home and Building Control
Honeywell
1985 Douglas Drive North
Golden Valley, MN 55422
60-0247√2
B.B. Rev. 2-01
RETURN
AIR DUCT
®
Motor. In applications with an M7034, an S963 can be used to provide remote
DUCT
AIR
CHAMBER
T7022
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Scarborough, Ontario
M1V 4Z9
M17818
Fig. 3. Duct or light troffer mounting
where wiring must be run in conduit.
T7022
M17821
Fig. 5. Cross section of light troffer showing a typical
mounting location at the end of the light troffer.
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
BOX MOUNTING
SHEET METAL
SCREWS
OPTIONAL
EXTENSION TUBE
MOUNTING
BRACKET
OUTLET BOX
TO
DUCT OR
PLENUM
SHIELD
www.honeywell.com/building/components
M17819
M17820
Advertisement
