Operating Your Electronic Air Cleaner - Honeywell W8600F Owner's Manual

OPERATING YOUR ELECTRONIC AIR CLEANER

Set the ON-OFF switch in the power box to ON.
NOTE: Depress 1 for ON, 0 for OFF.
The air cleaner will now operate whenever your
furnace/air conditioning system fan operates. For
maximum air cleaning benefit and cleaner air
M3584
conditioner coils, leave the air cleaner switch ON
at all times and the fan switch on your thermostat
ON. Of course, continuous fan operation will add
to your electric bill each month.
When the fan and air cleaner come on, the neon
indicator lights.
M3586
If your air cleaner is equipped with a wall-
mounted W8600F Air Cleaner Monitor (see page
ON
BATTERY
2), the ON indicator will be active whenever the
SERVICE
FAULT
air cleaner is in operation . Of course, the system
Air Cleaner Monitor
fan will also be running.
M11980
You may hear a snapping (electrical arcing)
sound occasionally as the air cleaner operates.
This usually is caused by a larger dust particle
causing a high voltage discharge. The snapping
sound means that your air cleaner is working as it
should. To hear the snapping sound, momentarily
press the test button near the bottom of the door.
M 6032
Use the test button any time you want to prove
air cleaner operation.
When the fan and air cleaner stops, the neon
light goes out, as does the ON indicator on the
M3585
W8600F. The air cleaner is off until the heating or
air conditioning and fan start again.
ON
BATTERY
SERVICE
FAULT
Air Cleaner Monitor
M11981
3
69-0756B—2