Advertisement
The plow
correctly landed when the
is
running
clearance
between the lower links
and the tires
approximately equal, and the
is
upper link extends straight behind the
tractor.
The plow bottom reacts like
the
ground
engaged. If the plow point
is
far from the left of the
a
adjust,
loosen the bolts attaching the
landside of the standard and
adjusting bolt clockwise two turns. Retighten
the attaching bolts. Repeat the adjustment,
Leveling
With the tractor running in a previously
plowed furrow at the desired depth and width
of cut, stop the tractor with the plow in the
ground and inspect the unit from the
The standard should be near vertical from
the ground. If it appears to lean to the right,
raise the right side link by turning the rod
or lower the left side by turning
clockwise,
rod counterclockwise. Reverse the
adjustments for a left-leaning standard.
coulter
The coulter should
slice
adjust,
loosen
the clamp securing the
standard and raise or lower the
Also, check the blade swing: It should be free
to m n g outward a limited-amount from the
beam
but should not swing in to touch the
or plow bottom. Adjust the stop pin as
beam
required.
a
rudder while
too
is
the plow will
b e a m ,
wall.
To
turn
the land
if
rear.
its
-
LOOSEN THESE BOLTS
BEFORE ADJUSTING
LAND ADJUSTING BOLT
TOP VIEW
N
Advertisement
