Advertisement
7. Insert the standard into the hub on the
equal amount of the pin extending on
each side of the hub.
8. Assemble the coulter blade hub to the
blade using three carriage bolts, flat
washers,
hex lock nuts.
9. Assemble the fork and coulter with the
axle, aligning the squares. Install two flat
washers. and secure with the cotter pin.
Bend the legs of the pin over the axle.
Mount the coulter/fork assembly on the
10.
left side of the plow beam using the
clamp and U-bolt. Insert two spacers
between the beam
U-bolt with 94" hex nuts: tighten the nuts
securely.
After assembly, refer to PLOW
to set the coulter.
1 1.
Install the hub on the gauge wheel using
three
x
washers, and hex lock nuts.
Install the flat washer on the hex bolt,
12.
insert the bolt through the hub. then add
a second flat washer
Secure with the lock washer and hex nut
on the inside of the bracket as shown.
1 3 . Mount the gauge wheel assembly on the
plow beam standard using the short
U-bolt and secure with 94" lock washers
and hex nuts.
Preparing
for Use
Plow
After assembly, clean the moldboard with a
soaked in turpentine, kerosene or
rag
naphtha so that
dirt will
to the protective coating. The coating can be
removed with an old brick or a pumice stone,
but this usually isn't necessaq unless the
soil
too wet or stice.
is
in a well-ventilated area
Work
and handle cleaning materials
up any spilled liquid immediately
Wipe
make
the area is dry before
sure
tractor.
Leave
an
arms,
then secure the
the hex
nut.
and
j a m
be
likely to stick
less
care.
with
and
starting
the
SPACERS
SPACERS
WASHER
HEX BOLT
LOCK WASHERS,
NUTS
NUTS
WASHERS
BR A CKET
Advertisement
