Honda H2013 Operator's Manual page 20

Adjust Belt Tension
1. Locate the thin metal plate inside the
tensioner spring. This plate is the belt tension
indicator.
2. Loosen the jam nut on eye bolt side of the
turnbuckle, and then turn the turnbuckle until
the square tip of the belt tensioner indicator is
flush with the end of the tensioner spring.
Tighten the nut securely.
Install Crank Handle and Crank Support
Install the plastic grip onto the end of the
1.
crank handle rod.
Locate and remove the two 8 x 18 mm
2.
flange bolts on the left front side of the lawn
tractor frame, just to the rear of the left front
tire.
Install the crank support to the lawn tractor
3.
frame using two 8 x 25 mm hex bolts and 8
mm flat washers.
Install the grommet into the end of the crank
4.
support, then insert the crank handle
through the bushing. (The top most hole is
used for mounting the optional light kit.)
Slip the J-hook into the tip of the worm
5.
gear, then install the other end into the
crank handle. Secure it with a 2. 5 x 40 mm
spring clip.
POP
52152 (9610)
ADJUST TURNBUCKLE
SO INDICATOR IS
SPRING COIL
LEFT SIDE VIEW
/-
H
J - OO K
PIVOT PLATE ON
U-SHAPED BRACKET
HOOK BOLT
TENSION INDICATOR
(red plate inside spring coils)
CRANK SUPPORT
x 25 rnrn HEX BOLT (2)