Honda H2013 Operator's Manual page 14

SB2040 Snowblower
Discharge Chute Assembly
1. Install the discharge guard on the chute as shown using two 3/8-3/4" hex bolts, 3/8" flat washers,
3/8" lock washers and 3/8" hex nuts.
2. Place the antifriction ring onto the blower head; the ring is keyed to the blower head so only one
position fits.
3. Apply a generous amount of general purpose grease to the top lip of the antifriction ring.
4. Install the long (1-11/16") plastic bushing into the worm gear bracket. Apply grease to the inside
surface of the bushing.
DISCHARGE GUARD
1/4" x 3/4" HEX BOLT (2)
1-5/16'' PLASTIC BUSHING
WORM GEAR
5. Grease the inside of the shorter (1-5/16") plastic bushing then slide it onto the short shaft of the worm
gear. Grease the long shaft on the worm gear, and install it into the bushing on the worm gear bracket.
6. Position the chute on the blower head. Get a helper to hold it in place if needed.
7. Install the two front retaining plates using four 1/4 x 3/4" hex bolts, lock washers and hex nuts.
8. Install the short shaft of the worm gear (with bushing) into the
bracket on the blower head.
9. Use the 1/4 x 3/4" hex bolts to install the left rear retaining plate
along with the crank handle bracket.
10. Apply a generous amount of general purpose grease to the worm
gear and chute gear teeth.
11. Use the longer, 1/4 x 3/4" hex bolts to secure the right rear
retaining plate, hold-down bracket, and the plastic chain cover.
POP 521 52 (961 0 )
Assembly and Installation
3/8" HEX NUT (2)
3/8" LOCK WASHER (2)
3/8" FLAT WASHER (2)
1/4" 3/4" HEX BOLT (6)
X
- RETAINING PLATE (3)
1/4" HEX NUT (6)
1/4" L
1/4" HEX NUT
3/4" HEX BOLT
13