Honda H2013 Operator's Manual page 18

SB2040 Snowblower
Connect Drive Belt & PTO Rod
1. Make sure the mower deck belt guard around the
crankshaft pulley has been moved out of the
way. This is typically done when the mower deck
is removed.
2. Make sure the PTO clutch lever is OFF.
3. Install the snowblower drive belt to the
crankshaft pulley, then install the belt guard.
Tighten the silver-colored flange bolt securely.
4. Install the connecting rod from the pivot on the
u-shaped bracket to the slot on the PTO rod
using the two flat washers and 2 x 26 mm
spring clip. Make sure the connecting rod is
positioned on the right-hand side of the pivot.
Connect Turnbuckle
1. Unthread the eye bolt side of the turnbuckle
and install a 5/16" jam nut onto the eye bolt
threads, then install the eye bolt back on the
turnbuckle.
2. Connect the hook bolt end (tip of hook bolt
must face out to the left side of the lawn
tractor) of the turnbuckle to the pivot plate on
the u-shaped bracket, and the eye bolt end of
the turnbuckle to the tension spring on the belt
tensioner pulley assembly.
POP 521 52 (961 0)
FLAT WASHER (2)
and
2 x 2 6 m m
SPRING CLIP
LEFT SIDE VIEW
SILVER
FLANGE BOLT
PIVOT PLATE ON
U-SHAPED BRACKET
I
HOOK BOLT
17