Honda BC4050 Operator's Manual page 9

Install the lift handles, using four
6.
inch pan-head screws, four
lock
washers, and four
Tighten the nuts and screws securely.
7. Install the support tube, using four
5/16 x 1 inch hex bolts, two
plastic spacers, and four
Place the plastic spacers only on the upper
bolts, as shown.
Tighten the nuts and bolts securely.
x
inch
HEX BOLT (4)
1/4 inch
.
1/4 inch nuts.
LOCK WASHER (4)
PAN-HEAD SCREW
5/16 inch
6 inch lock nuts.
SUPPORT
FLAT WASHER (4)
Thread the three rods through the cover:
8.
a.) Thread the support rod through the support
rod sleeve as shown.
b.)
Thread the frame rod through the frame rod
sleeve as shown. Be sure to position the
frame rod so the washer is on the upper
side.
upper
Washer on
side of rod
FRAME ROD SLEEVE
c.) Thread the straight rod through the straight
rod sleeve as shown.
ASSEMBL Y
-
Page
3