Converting A New Phone From Sccp To Sip; Converting An In-Use Phone From One Protocol To The Other; Deploying A Phone In An Sccp And Sip Environment - Cisco 7962G Administration Manual

Using Cisco Unified IP Phones with Different Protocols

Converting a New Phone from SCCP to SIP

A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:
Procedure
Step 1 Take one of these actions:
•
•
•
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about
Cisco Unified Communications Manager configuration. Refer to Cisco Unified Communications
Manager Bulk Administration Guide for detailed information about using BAT.
If you are not using DHCP in your network, configure the network parameters for the phone.
Step 2
See the
Save the configuration updates, click Apply Config, click OK in the Apply Configuration Information
Step 3
window, and have the user power cycle the phone.

Converting an In-Use Phone from One Protocol to the Other

For information on how to convert an in-use phone from one protocol to the Other, see the Cisco Unified
Communications Manager Administration Guide, chapter "Cisco Unified IP Phone Configuration,"
section "Migration Existing Phone Configuration to a Different Phone."

Deploying a Phone in an SCCP and SIP Environment

To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP and in which the
Cisco Unified Communications Manager Auto-Registration parameter is SCCP, perform these general
steps:
1.
2.
3.
4.
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
2-12
To auto-register the phone, set the Auto Registration Phone Protocol enterprise parameter in
Cisco Unified Communications Manager Administration to SIP.
To provision the phone by using the Bulk Administration Tool (BAT), choose the appropriate phone
model and choose SIP from BAT.
To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration
window in Cisco Unified Communications Manager Administration.
"Configuring Startup Network Settings" section on page
Set the Cisco Unified Communications Manager Auto Registration Protocol enterprise parameter to
SCCP.
From Cisco Unified Communications Manager Administration, choose System > Enterprise
Parameters.
Install the phones.
Change the Auto Registration Protocol enterprise parameter to SIP.
Auto-register the SIP phones.
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
3-13.
OL-18913-01