SET-UP
Tools Required
• 12 mm wrench, 10 mm wrench, and a Phillips-head screwdriver
Unpacking
1. Remove all the cardboard. Inspect the loose parts. Missing parts
may be obtained from a servicing Honda snowthrower dealer.
Qty.
Description
4
Curved head bolt 8 x 40 mm
4
Flange nut, 8 mm
4
Curved washer, 9 mm
3
Phillips head shoulder screw 6 x 12 mm
3
Flange nut, 6 mm
2
Cable tie
2. Loosen and remove the curved-head bolt, flange nut and starter
bracket from the lower handlebar. Do not discard the hardware.
Assembly
1. Install the handlebar
with the hardware
shown. Tighten the
flange nuts securely.
9 mm CURVED
WASHER (4)
8 x 40 mm
FLANGE NUT (4)
Part number
90109-VA4-000
94050-08000
90501-898-000
90142-KG8-000
90207-PG6-010
8 x 40 mm
CURVED HEAD
BOLT (4)
39