Engine Oil
1. Change the engine oil (page24).
2. Remove the spark plug (page25).
3. Pour a tablespoon (5 ~ 10 cc) of clean
engine oil into the cylinder.
4. Pull the starter rope slowly several
times to distribute the oil.
5. Reinstall the spark plug.
6. Pull the starter grip until resistance is
felt. This will close the valves and
protect the engine from internal corrosion.
Lubrication
Apply a few drops of oil and a small amount of grease to the following
parts for lubrication and rust prevention.
H
CHUTE TENSION
BOLTS
AUGER SHAFT
BEARINGS
CHUTE HINGE PIN
G
G
STORAGE
G
AUGER CLUTCH LEVER
33