Advertisement
13. Route the terminal ends of the disarm switch
harness through the 12 mm hole you just drilled in
the dashboard lower cover. Secure the disarm switch
on the dashboard lower cover using the 12 mm and
washer provided. Tighten the nut securely.
DASHBOARD
LOWER COVER
DISARM SWITCH
14. Firmly push the terminals of the disarm switch into
the 3-pin connector provided until they click into
position.
15. Pull gently on the wires to verify that they are locked
in the connector. Make sure that the terminals are
positioned properly, then lock the connector.
Firmly push the terminals into
the connector until they click
into position.
Insert the tabs into the grooves, slide
the lock toward the front, and press
down on the end.
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
12 mm NUT
WASHER
PREDRILLED
HOLE
BLUE
WIRE
3-PIN
CONNECTOR
BLACK
WIRE
DISARM
SWITCH
Installing the Control Unit
16. Loosen the bolt on the right of the steering shaft,
then slide the slot of the control bracket under the
head of the bolt you just loosened.
CONTROL BRACKET
EXISTING BOLT
(Reuse on A/T
model vehicle.)
EXISTING BOLT
(Reuse on A/T
model vehicle.)
17. Align the upper hole in the control unit bracket with
the hole in the dash, and install the 6 x 12 mm
flange bolt supplied. Tighten the 6 x 12 mm bolt, and
the bolt you loosened in step 16 securely.
On A/T model vehicles, attach the control unit
bracket under the interlock control unit, and reuse
the existing bolt.
AII 20465 (9908)
INTERLOCK
CONTROL UNIT
(A/T Model only)
6 x 12 mm
FLANGE BOLT
(supplied)
SLOT
CONTROL BRACKET
HOLE
5 of 8
Advertisement
