Advertisement
12. Visually check the position of the spring adjusting
pin on both sides of the CD changer. If the spring
adjusting pins are not in the horizontal (H)
position, move the pins to the horizontal (H)
position by sliding them up with your fingers.
SPRING
ADJUSTING PIN
(H: HORIZONTAL)
LEFT LOCKING
COVER
(Included with CD
Changer kit)
SPRING
ADJUSTING
PINS
13. Remove the adhesive backing from the "L" and "R"
locking covers, and attach them to the sides of
the CD changer. Align the diagonally opposite
holes with the H and V positions.
14. Install the right changer bracket to the CD
changer using two 4 x 8 mm washer-screws, and
the two wire clips. Install the left changer bracket
to the CD changer using two 4 x 8 mm washer-
screws.
4 x 8 mm
WASHER-
SCREW
WIRE
RIGHT
CLIP
CHANGER
BRACKET
6 of 8
(V: VERTICAL)
RIGHT
LOCKING
COVER
(Included with
CD Changer
kit)
LEFT
WIRE
CHANGER
CLIP
BRACKET
4 x 8 mm
FRONT
WASHER-
SCREW
All 23607 (0205)
15. Attach one cushion tape to the rear of the CD
changer leaving half of the cushion tape extended
past the CD changer. Using scissors, cut the
cushion at the end of the CD changer. Fold the
ends down and around the end of the CD
changer.
RIGHT BASE
BRACKET
FLANGE
NUTS (4)
RIGHT
CHANGER
BRACKET
CD CHANGER
CUSHION
TAPE
LEFT CHANGER
BRACKET
16. Attach the cushion tape to the top of the left
changer bracket align the cushion tape already
attached. Fold the cushion tape around the CD
changer.
17. Insert the studs of the left and right base brackets
into the holes in the left and right changer
brackets, then install the four flange nuts on the
end of each stud. Tighten the four flange nuts and
four bracket bolts in step 10 on the bracket plates.
©
2002 American Honda Motor Co., Inc - All Rights Reserved.
LEFT BASE
BRACKET
LEFT CHANGER
BRACKET
CUSHION TAPE
Advertisement
