Advertisement
7.
Using 1/2 of an EPT seal attach it to the frame at
the location shown. Measure 450 mm from the
end of the BUS cable to the frame, then bundle up
the excess cable and secure it to the vehicle with
three wire ties.
EPT SEAL
Cut in half.
Bundle up
Secure to the
the excess
vehicle harness.
BUS cable.
8.
Attach 1/2 of an EPT seal to the edge of the
frame in the area shown.
1/2 EPT seal
(Clean with
isopropyl
alcohol.)
BUS
CABLE
50 mm
Cut
here.
9.
Near the edge of the driver's seat raiser make a
50 mm slit in the floor carpet with a utility knife.
Route the BUS cable under the floor carpet and
out the slit near the seat raiser.
©
2002 American Honda Motor Co., Inc - All Rights Reserved.
WIRE
TIE
FRAME
450 mm
BUS CABLE
FRAME
FLOOR
CARPET SLIT
10. Install the right and left base brackets to the
driver's seat raisers using two 6 x 12 mm flange
bolts for each bracket. Do not tighten the bolts yet.
RIGHT
BASE
BRACKET
Installing the CD Changer
11. Carefully unpack the CD changer. Remove the
three shipping clips, and discard the shipping
cover. Install an adhesive seal (included with the
CD changer kit) over each of the three clips holes.
Save the shipping clips for your customer in the
event the unit needs to be serviced.
All 23607 (0205)
6 x 12 mm
FLANGE
BOLT
LEFT
BASE
BRACKET
SHIPPING CLIPS (3)
SHIPPING COVER
(Discard.)
ADHESIVE SEALS (3)
5 of 8
Advertisement
