Table of Contents
Advertisement
Configuring the Cisco WAP4410N Wireless-N Access Point
Status
Status
STEP 1
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide
SSL Certification Management
To generate the certificate with the WAP device, click Export Certificate.
Generating a new SSL certificate restarts the secure Web server. The secure
connection will not work until the new certificate is accepted on the browser.
If an SSL certificate (with a .pem extension) exists on the WAP device, you can
install it to your computer as a backup. Browse to the certificate file and click
Install Certificate.
The Status section describes how to change the status settings for the access
point:
Local Network
The Status > Local Network page displays the access point's current status
information for the local network. To check local network status, follow these
steps:
Click Status > Local Network.
This page displays the status information of your access point:
-
PID VID—The WAP hardware model and version.
-
Software Version—The version of the access point's current software.
-
Local MAC Address—The MAC address of the access point's local
network interface.
-
System Up Time—The length of time the access point has been
running.
•
Local Network
-
IP Address—The access point's IP address as it appears on your local
network.
-
Subnet Mask—The access point's subnet mask.
-
Default Gateway—The IP address of your gateway or router. The value
used by other devices on your LAN.
6
50
Hide quick links:
Advertisement
Table of Contents
