Table of Contents
Advertisement
Unpack the Hardware
Check the contents of the box to make sure that all items are present before installing
the RPS:
1.
Place the container on a clean flat surface and cut all straps securing the container.
2.
Unpack the hardware from the box.
Carefully remove the hardware and place it on a secure and clean surface. See
Location.
3.
Remove all packing material.
4.
Make sure that all items are present. See
Note:
If any item is found missing or damaged, contact your local
NETGEAR reseller for replacement.
5.
Inspect the products and accessories for damage. Report any damage immediately.
Installation
Install the equipment in the sequence presented in this section:
1.
Select a location. See
2.
Install the switch. See
3.
Check the installation. See
4.
Apply power and check the LEDs. See
Select a Location
The RPS can be mounted in a standard 19-inch (48.26-centimeter) rack or left freestanding
(placed on a tabletop).
NETGEAR Managed Switch
Package
Select a
Location.
Install the
RPS.
Check the
Installation.
Connect to Power and Check the
Hardware Installation
9
Contents.
LEDs.
Select a
Advertisement
Table of Contents
