Troubleshooting - NETGEAR MR814 Installation Manual

Troubleshooting

No lights are lit on the router
The router has no power.
• Make sure the power cord is properly connected to the router.
• Make sure the power adapter is properly connected to a functioning power outlet. If it is
in a power strip, make sure the power strip is turned on.
• Make sure you are using the correct NETGEAR power adapter supplied with your router.
Test light remains lit
After you plug in the power adapter, the Test light should turn on and
then, after approximately 10 seconds, turn off.
If the Test light does not turn off, pull the adapter out of its power
source and then plug it in again. Contact NETGEAR if this doesn't solve the problem.
The Internet light doesn't light up
The Power light and at least one numbered light is lit, but the Internet
light isn't lit.
You have the wrong cable between the router and the modem. Use the
cable that came with the modem.
There is no numbered light lit for a connected device
There's a hardware connection problem.
• Make sure the cable connectors are securely plugged in at the router and the device.
• Make sure the connected device is turned on.
• Be sure the correct cable is used. For computers, use a Category 5 Ethernet patch cable. For
other devices, you may need a cross-over cable or may need to use the uplink port or uplink
switch. A device with Auto Uplink™ (MDI/MDIX) ports will adjust automatically.
13