NETGEAR MR814 Installation Manual page 12

Connect and Configure Other Computers
5
5
(optional)
Now that you have one computer set up to access the Internet through the router, you can
connect other computers so they can share the modem.
Wired Computers
1. Connect a Category 5 Ethernet patch
cable between another computer and
one of the remaining numbered
Ethernet ports on the router.
2. Check to make sure that the
associated port number light is lit.
The light flashes when data is being
transferred over the connection.
Note: If the numbered light isn't lit, go to Troubleshooting on page 13.
3. Go back to Installation Step 3
(pages 8 and 9) and go through
the sequence of steps applicable
for each computer.
4. Restart each computer.
5. Test each computer's connection
by going to NETGEAR's Web site
(www.NETGEAR.com) from each
computer.
Note: If you have more than 4
computers to connect to this router,
you must connect them to a hub or
switch (such as the NETGEAR 5-port or 8-port Fast Ethernet Switch) and then connect
the hub or switch to the router. By using hubs or switches, you may connect up to 253
computers to the router, although a maximum of 32 wireless computers are supported.
Wireless Computers
Note: Check the documentation that
came with your Wireless Adapter to
complete these items.
1. Set the computer's Wireless Network Name
(SSID) to the same name as the router. The
default is Wireless.
2. Set the computer's Security Encryption (WEP)
to match the router settings. The same
Passphrase must be used on all devices or all
must be disabled. The default is Disabled.
Cable/DSL Wireless Router MR814
Note: Case Sensitive
11