Hitachi GR2000 Series Configuration Commands page 406

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 5-4
Duplicate relay address.
Duplicate subject IP address.
Duplicate vlan.
Inconsistency has occurred in a setting of
IPv6 address and NDP.
Interface name not specified.
Invalid connect type.
Invalid critical interface name.
Invalid destination IP address.
Invalid host address.
Invalid IP address.
Invalid name <name>.
Invalid network class.
Invalid policy routing interface name.
IP address is duplicate between interface and
static NDP entry.
IP address not specified.
IP configuration not specified.
IP configuration not specified.
IP interface is not defined.
MAC address not specified.
Maximum number of IP address are already
defined.
5-16
IP Information Error Messages (continued)
Duplicate relay address. Set all of the DHCP relay addresses to
unique.
The same IP address is used. Make each IP address unique.
The same VLANs are set in the same physical port. Make settings so
that VLANs in the same RP are unique.
There is a conflict in the prefixes between the address set by the IP
information and the address set by the NDP information. Designate
the address prefixes correctly.
Interface name not specified. Set interface name. Enter a correct
interface name.
The connection type is illegal. On an ATM or ISDN PPP line, if the
connection type is "broadcast," you cannot set IPv6.
The error monitoring interface name is illegal. For the error
monitoring interface name, use a name other than AUX.
Destination IP address value invalid. Set a correct destination IP
address
Host address is 0 or ALL 1. Specify the value so host address is
neither 0 nor ALL 1.
IP address value invalid. Set a correct IP address.
Entered name of configuration information invalid.
For group: Specify DLCI name on the same RP already defined.
For PPP, frame relay: Specify line name whose line type is serial,
oc3pos,
oc12pos, or name of timeslot.
For DLCI: Specify name set in frame relay.
For timeslot: Specify line name whose line type is pri, j2, bri.
For filter interface, qos ip: Specify line name of the line where IP is
set.
For QoS interface: Specify name set in ethernet, frame relay, dlci,
ppp.
For IP: Specify name set in ethernet, frame relay, dlci, ppp, vc, ISDN
PPP, Group, Tunnel.
For ARP: Specify name set in ethernet, dlci, vc, ISDN PPP.
For Virtual Router: Specify the name of a line other than AUX for
which the IP is set.
For Policy List: Specify the name of a line other than rmEthernet and
AUX for which an IP is set.
For Relay Interface: RmEthernet for which an IP is set.
Specify an interface name other than AUX.
<name>configuration information name
IP address network class does not match subnet mask network
class. Correct IP address network address and subnet mask class.
Policy routing interface name is invalid. For the name of the interface
for policy routing, use a name other than AUX.
The address set by the IP information is duplicated with the address
set by the NDP information. Designate the addresses without
duplication.
IP address has not been specified. Specify an IP address.
IP routing has not been specified. Specify IP routing.
IP routing has not been specified. Specify IP routing.
You are about to set the relay interface without IP routing.
Before setting the relay interface, make IP routing settings.
MAC address has not been specified. Specify MAC address.
No more IP address can be set. Check the network configurations.
GR2K-GA-0014
Ver. 07-02